User’s Manual
AKUNA THE VELOCIRAPTORTM
© 2013 VTech
Printed in China
US
91-002813-000
INTRODUCTION
Hiii-yaaa! I am Akuna the VelociraptorTM, and my ninja fighting
skills will amaze you! I use my lightning fast speed to outrun my
prey. And when I catch them, watch out! I have a long, curved claw
on each foot that can end a fight with one strike.
But I’ve saved my most impressive skill for last. I can change shape
and transform into a motorcycle! Now watch me disappear! Vroom,
vroom! Sayonara!
Sound Button
On/Off Switch & Volume Control
Talk Button
Light-up
Eyes
2
INCLUDED IN THIS PACKAGE
•
One VTech® SWITCH & GO DINOS®: Akuna the VelociraptorTM
•
One user’s manual
WARNING:
All packing materials, such as tape, plastic sheets, packaging
locks and tags are not part of this toy, and should be discarded
for your child’s safety.
ATTENTION:
Pour la sécurité de votre enfant, débarrassez-vous de tous
les produits d’emballage tels que rubans adhésifs, feuilles de
plastique, attaches et étiquettes. Ils ne font pas partie du jouet.
NOTE:
Please keep the user’s manual as it contains important information.
GETTING STARTED
BATTERY INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the
bottom of the unit.
3. Install 1 new “AA” (LR6/AM-3)
battery following the diagram inside
the battery box. (The use of new,
alkaline batteries is recommended
for maximum performance.)
4. Replace the battery cover to secure it.
NOTE:
When the battery runs low, the toy will no longer respond. If this
happens, please replace the battery.
3
BATTERY NOTICE
•
•
•
Use new alkaline batteries for maximum performance.
Use only batteries of the same or equivalent type as recommended.
Do not mix different types of batteries: alkaline, standard (carbon-
zinc) or rechargeable (Ni-Cd, Ni-MH), or new and used batteries.
•
•
•
•
•
•
•
•
Do not use damaged batteries.
Insert batteries with the correct polarity.
Do not short-circuit the battery terminals.
Remove exhausted batteries from the toy.
Remove batteries during long periods of non-use.
Do not dispose of batteries in fire.
Do not charge non-rechargeable batteries.
Remove rechargeable batteries from the toy before charging (if
removable).
•
Rechargeable batteries are only to be charged under adult
supervision.
PRODUCT FEATURES
1. ON/OFF SWITCH & VOLUME CONTROL
This product has a single switch that
turns the unit ON or OFF and controls the
volume.
To turn the unit ON or adjust the volume,
slide the switch to Low/High.
To turn the unit OFF, slide the switch to
OFF.
4
2. TALK BUTTON
Press the Talk Button to hear the dino
or driver talk.
3. SOUND BUTTON
Press the Sound Button to hear cool
sound effects.
4. AUTOMATIC SHUT-OFF
To preserve battery life, the unit will automatically power-off after
several minutes without input.
HOW TO SWITCH THE DINO TO A MOTORCYCLE
1. Dinosaur shape.
2. Rotate the body all the way
back until it meets the tail.
5
3. Move the head forward as
far as it will go.
4. Turn the back wheel 90
degrees.
6. Flip the legs up.
5. Pull down the kickstands
so that the motorcycle can
stand up.
7. Move the tail pipes down.
8. Motorcycle shape.
Note:
To change the motorcycle back into a dino, reverse the order of the
6
steps above.
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct heat
source.
3. Remove the batteries when the unit is not in use for an extended
period of time.
4. Do not drop the unit on hard surfaces and do not expose the unit to
moisture or water.
TROUBLESHOOTING
If for some reason the unit stops working or malfunctions, please follow
these steps:
1. Please turn the unit OFF.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit ON. The unit should now be ready to play again.
5. If the product still does not work, replace with a new set of batteries.
If the problem persists, please call our Consumer Services Department
at 1-800-521-2010 in the U.S. or 1-877-352-8697 in Canada, and a
service representative will be happy to help you.
NOTE:
This equipment generates and uses radio frequency energy and if
not installed and used properly, that is, in strict accordance with the
manufacturer’s instructions, it may cause interference to radio and
television reception. It has been type tested and found to comply
within the limits for a Class B computing device in accordance with the
specifications in Sub-part J of Part 15 FCC rules, which are designed
to provide reasonable protection against such interference in a
residential installation. However, there is no guarantee that interference
7
will not occur in a particular installation. If this equipment does cause
interference with radio or television reception, which can be determined
by turning the equipment on and off, the user is encouraged to try to
correct the interference by one or more of the following measures:
•
•
•
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected
•
Consult the dealer or an experienced radio/TV technician for help
Caution: changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC
RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING INTERFERENCE
THAT MAY CAUSE UNDESIRED OPERATION.
THIS CLASS B DIGITAL APPARATUS COMPLIES WITH
CANADIAN ICES-003.
CET APPAREIL NUMÉRIQUE DE LA CLASSE B EST
CONFORME À LA NORME NMB-003 DU CANADA.
8
|