KITCHEN SINK Model No. KSEU-3020
OWNER’S MANUAL
MODEL NO.
CAUTION:
Read ALL instructions carefully
BEFORE starting your installation.
Save this manual for future reference.
Installation
Care and
Cleaning
KSEU-3020
Patent Pending
Installation • Care and Cleaning
CUT INSIDE OF LINE
DRILL STARTER HOLE
INSIDE OF CUTOUT
LINE
3. Drill starter hole inside of cutout line.
4. Using a saber saw, cut inside of cutout line. Trial fit sink to
check proper fit.
IMPORTANT
The Euro Style sink design allows for
the drainboard to be located on either
the left or right side. After you decide
on the location of the drainboard, the
fixture holes can then be located.
NOTE
Drill Starter Hole From Bottom
Finish Drilling Hole From Top
5. Fixture hole locations are identified with a gray label indicating
the most desired placement. Drill starter hole from reverse side.
Working from the top side as illustrated, position a hole saw on
the starter hole and drill to complete the fixture hole. Clean out
fixture hole with a knife or file. (See Caution). Attach faucet,
drain, and accessories according to manufacturer’s instructions.
6. Attach sink clips as illustrated to underside of sink. Sink clips
provided will accommodate a counter top up to 1-1/2Љ (38mm)
thick.
CAUTION
Use of a hole saw is preferred, however, if punch is used, insure
that ledge is supported and punch is placed directly in middle of
knock-out area. If hole is not used, peel off the label.
KITCHEN SINK Model No. KSEU-3020
Installation • Care and Cleaning
APPLY
CAULK
7. Apply a bead of caulk (not included) to the underside of the
sink flange and position sink into counter top opening. First,
tighten screws in front, then tighten rear screws.
8. Connect all faucet supply lines, disposal (if available), and
drain trap fittings per manufacturer instructions.
CHECK FOR LEAKS:
• Supply user tubes to faucet
• Supply riser tubes to shut off valves or lower connections
• Fill sink with water and check for leaks around drain
• Release water from sink and check for possible leaks
• Tighten as needed
CLEANING
REPAIRING
Solid Colors
Clean your Swanstone kitchen sink as you would any other fine
bath fixture, using normal household detergents and cleansers.
Just wiping the wall surfaces quickly removes watermarks and
residue. Occasional scrubbing with household abrasive cleansers
ensures that the original luster is maintained, similar to tile and
other permanent type bath fixture materials.
Use 400 grit sandpaper to remove scratches and gouges in the
surface. A “scotchbright pad” can be used to blend in the area.
Aggregate Colors
Use 400 grit sandpaper to remove scratches and gouges in the
surface. To blend in the area use a fine grade, white, automotive
polishing compound or paste wax.
Patent Pending
Form #400-1-94-10M
|